Driftcon hardware box installation guide
Windows 10 Driftcon hardware box driver installation guide

1 Connect the USB cable to the hardware module.
2 Connect the USB cable to the computer or notebook.

3 Press the Windows key to open the Start menu and search for ‘Device manager’

4 Or press the Windows key + X and select ‘Device manager’

5 Right-click ‘Driftcon III Serial port’ as shown below and select ‘Update Driver Software...’

6 Select ‘Browse my computer for driver software’

7 Click on ‘Browse…’ to select the folder where the drivers are located (typically C:\Program Files\GENO-tronics BV\Driftcon\Drivers\GENO-tronics BV Hardware box driver). Click ‘Next >’ to proceed.

8 Click on 'Install' to proceed with the installation.

9 Click 'Close'.

10 Please follow steps 3 to 9 again to install the Driftcon Serial Port.
11 Verify the installation by looking at the green flashing LED for hardware box II or permanent green LED for hardware box III. If problems arise with the installation, please contact CYCLERtest BV.